Substrates	Well-Sanded, Completely dried and good existing finishes as bellow: A .original paint B. Old paint firm C. 1K or 2k primer
Surface Cleaning	Wash by warm soap, remove wax, silicon and other contaminations with degreaser, sanding with P800-P1000, wash with clean water then keep dry; again with degreaser.
Mixing Ratio	Faralli 2K Solid Colors		Hardener		Thinner
	2		1		0.2-0.4
＜15℃	Faralli 2K Solid Colors		MS120 Fast Hardener		602 Fast Thinner
15-30℃	Faralli 2K Solid Colors		MS120 Standard Hardener		602 Standard Thinner
＞30℃	Faralli 2K Solid Colors		MS120 Slow Hardener		602 Slow Thinner
Spray Viscosity	16-19s to drop off, in 4# viscosity cup, at 25°C,
Pot-life	At 25°C 2 hours with fast hardener. 4 hours with standard or slow hardener.
ReTreatment	There are particles or runs after spray, sand affected area with P2000 sand paper after thorough drying, then polish to solve the problem.
Spray Gun Set Up	Gravity Feed: 1.2-1.5mm 3-5kg/cm 2 Suction Feed: 1.4-1.6mm 3-5kg/cm 2
Spray Technology	Coats&Thickness: 2-3 coats, total 35-50um Flash-Off Time: At 25°C, 5-10 minutes between two coats, Air-Drying Time: Allow 10-15 minutes air drying time before force drying
Drying Time	Temperature	Dust Free	Tack Free	Dry To Handle	Dry To Test
	+25°C	40 minutes	2 hours	9 hours	6 Days
	+70°C	5 minutes	10 minutes	25 minutes	50 Minutes
Shelf Life	2 years in original sealed can, cool and dry place at 25℃.
Package	1L12 or 3.75L4

Note

The substrate must be cleaned and sanded before spray, wet sanding P800-1000 and then dry.

At ambient temperature higher than 30℃, add appropriate Retarder Solvent into thinner to avoid blushing.

For more details, please refer to technical data sheet of Retarder Solvent.

The products mixed with hardener should be used up soon and can not be restore for future use;

Clean equipments immediately with thinner after application, otherwise it is very difficult to be cleaned after dry.

Practical Multiscene Car Top Coat Weatherproof Metallic Vehicle Paint

Refinish Car Paint